Table of Contents
Advertisement
drive installation
Surface Mounting
Model Size
1
2
Dimension
A
345
345
[13.56]
[13.56]
C
47.5
95
[1.88]
[3.75]
E
16.5
[.63]
E1
E2
E3
F
368
368
[14.25] [14.25] [14.25] [29.25]
G
95
190
[3.75]
[7.50]
H
200
200
[7.88]
[7.88]
L
335
335
[13.19]
[13.19]
Mounting
6.5 [.16] clearance or
1
/
hole diam.
4
Dimensions in mm and [inches].
20
3
4
345
716
[13.56]
[28.19]
187.5
250
[7.38]
[9.81]
16.5
[.63]
17
[.63]
65
[2.56]
143.5
[5.63]
368
743
375
500
[14.75]
[19.69]
260
260
[10.25] [10.25]
335
700
[13.19]
[27.56]
UNF M6 thread
G
L F A
C
H
G
L F A
C
G
L F A
C
G
H
C
L F A
Panel
Panel
E
E
Panel
E
E
E1
E1
Panel
E2
E3
E3
E2
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Unidrive Servo Series and is the answer not in the manual?
Questions and answers
Need to input parameters into a UNI2402 Unidrive for a Rover 346
Need to input parameters into a UNI2402 Unidrive for a Rover 346 To clarify, it is a Biesse Rover 346... a c&c Machine Thanks
The parameters for a Control Techniques UNI2402 Unidrive Servo can be input using the on-board keypad, a remote keypad, or through UniSoft, a Windows-based configuration software tool. The drive has logically organized menus where parameters can be set.
To input parameters:
1. Use the keypad to navigate through the menus.
2. Select the required function from the logically organized menus.
3. Adjust the parameter values as needed.
4. Save the changes to apply the new settings.
For a Rover 346, specific motor and operational parameters should be set according to the motor’s requirements, such as speed limits, acceleration/deceleration times, braking mode, and PID control settings. If using UniSoft, connect the drive to a PC and configure it through the software interface.
This answer is automatically generated