Table of Contents
Advertisement
introduction to macros
Macro 7 – Brake control
This macro essentially allows the control of an
external brake. The brake is released when the drive is
running and there is current in the motor.
Drive Connections
Speed Input
from PLC
Thermistor
Speed Output
Load Output
Brake Release Output
Drive Reset Input
Run Forward Input
Run Reverse Input
External Trip Input
Speed
Run Forward
& Current
& Reverse
x 1
0-10V DC
Brake Release
Thermistor
Output
1
2
3
4
5
6
7
8
9
10
11
21
22
23
24
25
26
27
28
29
30
31
x 2
External
Reset Input
Macro 8 – Digital Lock
The digital lock macro enables a drive to be
operated so that it will lock two motor shafts together
pulse for pulse.
Reference Counts
Accumultor
Feedback Counts
Drive Connections
Thermistor
Speed Output
Load Output
Drive At Speed Output
Drive Reset Input
Relative Jog Input
Run Forward Input
Run Reverse Input
Enable Input
Speed
Run Forward
& Current
& Reverse
Thermistor
only
Relative Jog
Input
Feed Forward
+/- Error
Feedback
1
2
3
4
5
6
7
8
9
10
11
21
22
23
24
25
26
27
28
29
30
31
x 2
External
Reset Input
Capatan
Take Up
M
M
11
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Unidrive Servo Series and is the answer not in the manual?
Questions and answers
Need to input parameters into a UNI2402 Unidrive for a Rover 346
Need to input parameters into a UNI2402 Unidrive for a Rover 346 To clarify, it is a Biesse Rover 346... a c&c Machine Thanks
The parameters for a Control Techniques UNI2402 Unidrive Servo can be input using the on-board keypad, a remote keypad, or through UniSoft, a Windows-based configuration software tool. The drive has logically organized menus where parameters can be set.
To input parameters:
1. Use the keypad to navigate through the menus.
2. Select the required function from the logically organized menus.
3. Adjust the parameter values as needed.
4. Save the changes to apply the new settings.
For a Rover 346, specific motor and operational parameters should be set according to the motor’s requirements, such as speed limits, acceleration/deceleration times, braking mode, and PID control settings. If using UniSoft, connect the drive to a PC and configure it through the software interface.
This answer is automatically generated