Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Control Techniques COMMANDER S100
Summary of Contents for Control Techniques COMMANDER S100
- Page 1 Step By Step Guide COMMANDER S100 Part number: 0478-0644-01 Issue: 1 MARSHAL...
- Page 2 Users must not attempt to repair a drive if it is faulty. It must be returned to the supplier of the drive. The UL file reference is: NMMS/7.E171230. The product is UL listed for use on a circuit up to 10 kA maximum supply symmetrical fault current, when protected by fuses. 600 Volts AC Maximum. Commander S100 Step by Step Guide...
-
Page 3: Features Of The Drive
The Commander S100 is fully compatible with the mobile app, Marshal, which can be found on Google Play and the App Store, or alongside the full Commander S100 User Guide at 'www.drive-setup.com' MARSHAL •... -
Page 4: Step 2: Wire The Drive
Run Reverse... Reference Select... Analog Output Drive Healthy Relay Normally Open Ramp Output Relay Common Drive Unhealthy Relay Normally Closed For other IO configurations see Control Connections section in the User Guide or use Marshal. Commander S100 Step by Step Guide... - Page 5 (104 °F). For UL, cables must be rated for 75 °C (167 °F) operation and copper only. To fit a ferrule, 90 °C (194 °F) rated cable with a reduced cross section is required for some drives. The voltage rating of fuses and MCBs must be greater than or equal to the highest supply voltage of the system. Commander S100 Step by Step Guide...
-
Page 6: Step 3: Run The Motor
The following workflow uses the default settings of Frequency Reference Configuration P0.05 and Enable/Run Configuration P0.10. For information on the setup of these parameters see their descriptions in Marshal or the Parameter section of the Commander S100 User Guide. Action... - Page 7 RUN signal if enable/run configuration is set appropriately. On the diagram above this indicates that the key should be pressed Press and Hold and held for 1 second opposed to a normal short press. Commander S100 Step by Step Guide...
- Page 8 Company information Control Techniques Limited. Registered Office: The Gro, Newtown, Powys SY16 3BE. Registered in England and Wales. Company Reg. No. 01236886. 0478-0644-01...
Need help?
Do you have a question about the COMMANDER S100 and is the answer not in the manual?
Questions and answers