Table of Contents
Advertisement
No. 2D730-148E*O
14.
UPGRADING
THE SOFTWARE
This subsection describes the standard procedure for upgrading the software.
If special operation
is required, the corresponding
instructions will be provided.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
Turn ON the power supply to start the system.
Perform backup as required and display the
service menu screen.
Input the command "stopzjs"
on the Utilities Command
Line and click
Go to stop the system software.
The service menu screen disappears.
Select the Start button + Program + Accessory + Command
prompt and then execute the
"tus-stopAplio.js"
command.
Terminate the command prompt.
Reboot the system by clicking the Start button and selecting Restart from the menu.
After restarting the system, upgrade the software.
An example of the upgrade procedure is given below.
l
Delete the "Zm/Orca Combined..."
and "Zhui" applications using "Add/Remove
Programs"
of "Control Panel".
l
Start Explorer.
If "C:\Hui" or "C:\Zdt" exists, delete the whole folder.
l
Execute the ".setup.bat" command
on the APPLI DISK MO.
After upgrading the software, execute the "tus-restartAplio.js"
command and terminate the
command
prompt again.
Shutdown the system by clicking the Start button and selecting Shutdown from the menu.
Then restart the system and confirm that it starts normally.
Display the service menu and perform restoration as necessary.
If restoration is performed,
the system shuts down.
Restart the system and complete the
procedure.
14-1
Advertisement
Table of Contents
