Act (Option) - Toshiba Aplio SSA-770A Service Manual

No. 2D730-148E*O
(34) ACT (option)
If the optional ACT measurement program is installed, defaults for ACT measurement can be
preset. On this screen, 3 pages are provided for ACT measurement.
0 Page 1
Item
Annular Tracking
(Advanced)
Contour Display
Annular Display on
Advanced mode"
Average
Setting
Disable
Enable
Off
On
Off
On
Off
On
Function
Disables the annular tracking assessment function during
ACT measurement.
--------------------------------------------------------------------------
Enables the annular tracking assessment function during
ACT measurement.
The [Advanced], [Copy to File], [Annular Disp.], and
[Trajectory Disp.] switches are displayed on the touch
panel for LV ACT.
Turns OFF the contour display.
--------------------------------------------------------------------------
Turns ON the contour display.
Turns OFF display of the annular position mark.
--------------------------------------------------------------------------
Turns ON display of the annular position mark.
Specifies the measurement and calculation methods for LV
functions.
The LV functions are measured and calculated using the
data for only the cardiac cycle (between two successive
end diastoles) containing the currently displayed frame.
--------------------------------------------------------------------------
Specifies the measurement and calculation methods for LV
functions. The LV functions are measured and calculated
by averaging the data for the specified number of cardiac
cycles.
*I : This item is enabled only when "Annular Tracking" is set to "Enable".
II-55