Table of Contents
Advertisement
No. 2D730-148E*O
3.2
Removing the Covers
3.2.1
For the SSA-770A
(1)
Removing the left side cover
(a)
Remove the two rubber caps at the bottom of the cover.
(b)
Remove the two M4 screws <A> to remove the left side cover.
* The cover can be removed by pulling the bottom of the cover toward you
(2)
Removing the right side cover
Remove the right side cover in the same manner as the left side cover.
(3)
Removing the left side cover for peripheral units
It is necessary to remove the left side cover in advance.
Remove the two M4 screws <B> to remove the left side cover for the peripheral units.
* The cover can be removed by lifting it up and then pulling it toward you.
(4)
Removing the right side cover for the peripheral units
It is necessary to remove the right side cover in advance
Remove the two M4 screws CC> to remove the right side cover for the peripheral units.
* The cover can be removed by lifting it up and then pulling it toward you.
(5)
Removing the front cover
When the transducers
are connected,
remove them.
It is necessary to remove the right and left side covers in advance.
(a)
When the blank cover is installed, loosen the M3 screw CD> to remove the blank
cover with the printer base installed.
(b)
Remove the four M4 screws <E> to remove the front cover.
(6)
Removing the rear cover for the power supply
It is necessary to remove the right and left side covers in advance.
Remove the four M4 screws cF> to remove the rear cover for the power supply.
(7)
Removing the base front cover
It is necessary to remove the right and left side covers and the front cover in advance.
(a)
Remove the two M4 screws cG>
(b)
Loosen the two M4 screws <H> to remove the base front cover
* The cover can be removed by pulling it toward you slightly and lifting it obliquely.
3-5
Advertisement
Table of Contents
