Table of Contents
Advertisement
6.5.2
Starting the transfer
Introduction
To make a project executable on an HMI device, transfer the project from the configuration
PC to the HMI device. With a transfer, you particularly specify whether to overwrite existing
data on the HMI device such as "User management" or "Recipe data".
Requirement
● The project is opened in WinCC on the configuration PC.
● Project tree is displayed.
● configuration PC is connected to the HMI device.
● Transfer mode is set on the HMI device.
Procedure
Proceed as follows:
1. Select the "Download to device > Software" command in the shortcut menu of the HMI
device.
2. When the "Extended download to device" dialog opens, configure the "Transfer settings".
Make sure that the "Transfer settings" match the "Transfer settings on the HMI device":
– Select the protocol used, for example, Ethernet or USB.
– Configure the corresponding interface parameters on the configuration PC.
– Make the specific interface or protocol settings on the HMI device as required.
– Click "Download".
You can open the "Extended download to device" dialog at any time using the menu
command "Online > Extended download to device...".
The "Load preview" dialog opens. The project is compiled at the same time. The result
appears in the "Load preview" dialog.
3. Check the displayed default settings and change them, if necessary.
4. Click "Download".
Result
The project is transferred to the selected HMI device. If errors or warnings occur during the
transfer, alarms are displayed in the Inspector window under "Info> Download".
When the transfer is completed successfully, the project is executable on the HMI device.
Mobile Client900RXA
Operating Instructions, 07/2015, A5E36360099-AA
If you are using Ethernet, for example, you can also configure the network address in
the "Devices & Networks" editor in WinCC. You can find more information on this topic
in the WinCC online help.
Commissioning a project
6.5 Transfer
107
Advertisement
Table of Contents
