Table of Contents
Advertisement
4.4.3
Using the HMI device in password-protected security mode
If security mode has been activated, only the "Transfer" and "Start" buttons can be operated
without a password. To deactivate security mode, delete the password as described in
"Changing password protection (Page 64)".
Requirement
● A password has been assigned as described in "Changing password protection
(Page 64)".
● The security mode is displayed, similar to the figure below:
Procedure
1. Operate a password-protected desktop icon, the taskbar or the "Settings" or "Taskbar"
button in the Start Center.
The following dialog appears:
2. Enter the required password.
3. Confirm your entry with "OK".
The dialog will close and the selected operator control open.
Mobile Client900RXA
Operating Instructions, 07/2015, A5E36360099-AA
Parameter assignment of a Mobile Client
4.4 Security mode
49
Advertisement
Table of Contents
