Table of Contents
Advertisement
3. Select "Configure".
The following dialog appears:
If you do not enter a time, the message "Second field wrong data type." will appear. Enter
a time.
4. Enter the DNS name of the time server under "Name".
You can also enter the IP address of the time server.
5. Use "Test" to test the availability of the time server.
The communication connection to the time server is established and the time is displayed
on the "DateTime:" display. The IP address of the time server is also displayed in the
"Address" display.
6. Up to three additional time servers can be set up, if needed.
7. Confirm your entries with "OK".
The communication connection to the time server is now set up and immediately active.
4.9
Configuring network operation
4.9.1
Overview
You can use this function to configure the HMI device for data communication in a
PROFINET network via the Ethernet port.
Note
The HMI device can only be used in PROFINET networks.
The HMI device has client functionality in the local network. This means that users can
access files of a node with TCP/IP server functionality from the HMI device via the local
network. However, you cannot access data on the HMI device from a PC via the local
network, for example.
Information on communication with SIMATIC S7 over PROFINET is available at:
SIMATIC PROFINET system description
(http://support.automation.siemens.com/WW/view/en/19292127)
Mobile Client900RXA
Operating Instructions, 07/2015, A5E36360099-AA
Parameter assignment of a Mobile Client
4.9 Configuring network operation
81
Advertisement
Table of Contents
