Table of Contents
Advertisement
Parameter assignment of a Mobile Client
4.10 Functions for service and commissioning
● A SIMATIC HMI Memory card or an industrial grade USB flash drive with an HMI device
image file including the operating system is plugged into the HMI device.
You can find the HMI device image files, for example, in the installation directory of
WinCC under "\Siemens\Automation\Portal V13\Data\Hmi\Transfer\<HMI device image
version>\Images".
Procedure
The procedure is the same as steps 1 to 5 described in the section
"Restoring from external storage medium – Restore (Page 93)". Proceed as follows:
1. To restore the data from the selected file, select "Restore".
The following dialog appears:
2. Selecting "Yes" starts the restoration of the operating system.
The "Transfer" dialog appears. A progress bar shows the status of the restore process.
When the restore operation is completed, the Restore operation successfully completed.
message is displayed. The HMI device then restarts and remains in transfer mode.
The operating system is updated on the HMI device.
Note
After restoring, a recalibration of the touch screen may be required, see also section
"Calibrating the touch screen (Page 59)".
96
NOTICE
Data loss
All data on the HMI device including the project and HMI device password is deleted
during a restore operation. License keys are only deleted after a security prompt.
Back up data before restore operations, if required.
Operating Instructions, 07/2015, A5E36360099-AA
Mobile Client900RXA
Advertisement
Table of Contents
