Product Safety; Safety Instructions For Operation - meteocontrol Power Control Operating Manual

Information about this topic:
Operating manual Refers to another manual
WEB`log
Web portal
Inverter
2.2

Product safety

Power Control is a system for controlling and steering different operating
parameters of PV systems (such as reactive and active power).
The connections of the data loggers and modules used here may be loaded
with the permissible signals and signal strengths only.
Installation is only permitted indoors. For installation outdoors or in a dusty
environment, the device must be installed in a standardised protective
enclosure.
2.2.1

Safety instructions for operation

The following must be observed when the data logger is in operation:
•
•
•
•
Immediately take damaged devices out of operation and have them
checked by a qualified electrician.
•
•
The safety of the device and the operator cannot be guaranteed if the
device is operated in contravention of the described safety instructions
meteocontrol Power Control 03082012 - en
Documents on the inverter
Do not remove the memory card (compact flash) or SIM card.
Do not open the device.
Do not make any modifications to the device.
Observe local provisions when using the device.
WEB`log PRO operating manual
Documentation Web portal
9/78