Active And Reactive Power Procedures - meteocontrol Power Control Operating Manual

7.

Active and reactive power procedures

The procedures are set via Admin measurement > Power Control > General
settings.
The procedures cannot use any requirement sources and can also not be
combined.
•
A procedure for active power reduction can be selected without a
procedure for reactive power control being selected. (Selecting the
procedure for reactive power control is optional).
•
A procedure for reactive power control can only be selected if a
procedure for active power reduction was selected (selecting the
procedure for active power reduction is required).
•
An input screen for setting the procedures is displayed for the procedures
selected.
32/78 meteocontrol Power Control 03082012 - en