Control Via Remote Contacts - BONFIGLIOLI ACTIVE Manual

Profibus-dp, communication module cm-pdp, frequency inverter 230v/400v

Hide thumbs Also See for ACTIVE:

Manual (50 pages)

Operating instructions manual (32 pages)

Applications manual (30 pages)

Table Of Contents

Table of Contents

Note:

If transition 5 has been triggered with

control word is only accepted after the completion of the transition process. The

change of state from "Operation enabled" to "Ready" is done after the expiry of the

time

If the parameter

can be set back to 0x0F during the stoppage of the drive. In this way, the drive runs

back up to its set reference value and remains in the state "Operation enabled".

The change of state from "Operation enabled" to "Ready" is done after the set switch-

off threshold has been reached and expiry of the set holding time (equivalent to the

behavior in a quick stop). In this, the parameters

fmax) and

relevant.

10.2.4

In the operation mode

frequency inverter is controlled via the control word in PZD1, with the bits 0 to 5 cor-

responding to the contact inputs S1IND to S6IND. In addition, two virtual contact

inputs S7IND and S8IND are available. These virtual contact inputs are not supported

as a standard feature and are reserved for special applications. In the use of the re-

mote contact, the frequency inverter behaves in the same way as in control via the

hardware contact inputs. The meaning of these inputs can be seen from the operating

instructions.

Note:

State machine:

The values in the states report the feedback message via the state word (Bit 0 to 6) in

PZD1.

06/05

The default value for the parameter

mode "2 – Ramp". For configurations with torque control, the default

value is operation mode "0 - Coast to stop". In a switch-over of the con-

figuration, the setting value for

necessary.

Braking time

632 parameterized for the DC brake.

State transition 5

Holding time

638 (holding time after switch-off threshold reached) are