Introduction - BONFIGLIOLI ACTIVE Manual

2
This document describes the features of the Profibus-DP communication module CM-
PDP for the frequency inverter of the series ACT and ACU.
For the Profibus-DP connection, the frequency inverter must be equipped with the
Profibus-DP communication module CM-PDP. The Profibus component CM-PDP is en-
closed with the inverter as a separate part and must be fitted by the user. This is ex-
tensively described in the chapter "Assembly".
Note:
The Profibus component CM-PDP has the ident number 0x0696 (hexadecimal). The
device's data set file has the designation VEC_0696.GSD and is attached to the ap-
pendix of this documentation. Identification number and designation of the GSD file
have been assigned by the Profibus user organization in Karlsruhe.
Attention! With the help of the Profibus-DP communication module CM-PDP it is
6
6

Introduction

These instructions are not to be understood as fundamental information
on the Profibus-DP. They presuppose underlying knowledge of the meth-
ods and modes of effect of the Profibus-DP on the part of the user.
In some points, setting and display possibilities are described alterna-
tively to the control unit KP500 via the VPlus PC program. The operation
of a PC with the VPlus program on the frequency inverter with use of the
Profibus component CM-PDP is only possible via an optional interface
adapter KP232 on the slot of the keypad.
possible to access ALL parameters of the frequency inverter from the
external control. The control of the access by control levels with the
control unit KP500 or the PC software VPlus does not exist. A change of
parameters, whose meaning does not admit to the user can lead to the
inoperability of the frequency inverter.
06/05
06/05