Smartgen HGM400 Series User Manual page 15

Level Sensor
14
Open
Temp. Sensor
15
2 Open
Oil Pressure
16 Sensor
Open
Level Sensor 2
17
Open
High
18
Temperature 2
Low
19
Pressure 2
Low Fuel Level
20
2
Maintenance
21
Due
HGM400 Series Genset Controller
When the controller detects that the level sensor is open
circuit and the action select "Warn", it will initiate a warning
alarm and the corresponding alarm information will be
displayed on LCD.
If the config. sensor set as temperature sensor, When the
controller detects that the temperature sensor is open circuit
and the action select "Warn", it will initiate a warning alarm
and the corresponding alarm information will be displayed on
LCD.
If the config. sensor set as oil pressure sensor, When the
controller detects that the oil pressure sensor is open circuit
and the action select "Warn", it will initiate a warning alarm
2
and the corresponding alarm information will be displayed on
LCD.
If the config. sensor set as level sensor, When the controller
detects that the level sensor is open circuit and the action
select "Warn", it will initiate a warning alarm and the
corresponding alarm information will be displayed on LCD.
When the controller detects that config. sensor temperature
(sensor type: temperature sensor) has exceeded the pre-set
value while shutdown is prohibited, it will initiate a warning
alarm and the corresponding alarm information will be
displayed on LCD.
When the controller detects that config. sensor oil pressure
(sensor type: oil pressure sensor) has fallen below the
Oil
pre-set value while shutdown is prohibited, it will initiate a
warning alarm and the corresponding alarm information will
be displayed on LCD.
When the controller detects that config. sensor fuel level
(sensor type: level sensor) has fallen below the pre-set value
while shutdown is prohibited, it will initiate a warning alarm
and the corresponding alarm information will be displayed on
LCD.
When genset running time has exceeded the user setting
maintenance time and the action select "Warn", it will initiate
a warning alarm and the corresponding alarm information will
be displayed on LCD. The maintenance alarm will reset if the
action select "Inactive".
ISSUE 2015-05-27
HGM400 Series Genset Controller User Manual
Version 1.6 Page 15 of 44