Danfoss VLT Micro Drive FC 51 Programming Manual page 69

Troubleshooting
VLT
ALARM 91, Parameter value is not valid in this mode
Occurs when trying to write an illegal value to a
parameter.
ALARM 92, Parameter value exceeds the min/max limits
Occurs when trying to set a value outside the range.
Parameter can only be changed when the motor is
stopped. Err. A wrong password was entered, occurs when
using a wrong password for changing a password-
protected parameter.
6 6
68 MG02C602 - VLT
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-12769-Danfoss-132F0026-VFD-Micro-Drive-440V-5HP.aspx
®
Micro Drive FC 51 Programming Guide
®
is a registered Danfoss trademark