System Change During Operation - Siemens Simatic CFU Commissioning Manual

Operation planning

5.2 System change during operation

Note
Configuring messages
You can configure alarms for monitoring power supply and electronics temperature in the "CFU
Configuration; Commissioning Wizard - Step 2/6" dialog of SIMATIC PDM.
You can find information on this in section "Using a wizard for CFU configuration (Page 55)".
Additional information
● Additional information is available in the catalog ST PCS 7.
● You can find information about the technical specifications in section "Technical
specifications (Page 127)".
● You can find information about the power supply in section "Connecting the power supply
to the CFU (Page 38)".
● Section "Use in hazardous areas (Page 24)"
5.2 System change during operation
During operation of the CFU, you can carry out the following functions:
● Adding components
● Replacing components
● Deleting components
● Changing parameters
Parameters you can set in HW Config
Changing the plant during operation (configuring)
● The CPU 410-5H FW 8.2 or higher is used as the IO controller in the AS.
● The required device description is installed.
Information about installation with the Device Integration Manager is available in the help
for SIMATIC PDM.
Basic procedure
You can find additional information on the procedure in section "Servicing and maintenance
(Page 99)".
Additional information
Read section "Use in hazardous areas (Page 24)"
22
Commissioning Manual, 07/2018, A5E39252870-AC
SIMATIC CFU