Siemens Simatic CFU Commissioning Manual page 75

Object in HW Tab
1)
Config
Slot 0/X1 Pn R General
(parameter for a
port on the Bu‐
Addresses
sAdapter)
Identification
Topology
Options
Slot DIQ General
(Freely configu‐
rable channels)
Addresses
Parameter
Slot FB M General
(only for
CFU PA)
Parameter + di‐ General
agnostics
Addresses
Parameter
Status + notifica‐ General
tions
Addresses
SIMATIC CFU
Commissioning Manual, 07/2018, A5E39252870-AC
Explanations
Name for the PN/IO port on the BusAdapter
(Pn = P1 = Port 1 or Pn = P2 = Port 2)
Diagnostic address for the PN/IO port on the Bu‐
sAdapter
Higher level designation; location designation;
installation date; supplementary information
Partner port; line data
Recommendation:
Set these parameters in the topology editor.
(PROFINET installation > Topology
PROFINET functions > Topology and STEP 7)
● Transmission medium with transmission rate
● Autonegotiation
● Boundaries:
End of sync domain, End of detection of
accessible nodes, End of topology discovery
Name for the freely configurable channels of the
CFU
Inputs, outputs
You can specify the address range as follows:
● Automatically (System specification check
box)·
● Input of a start address.
Clear the "System default" check box and
enter the start address in the "Start" field.
For example channel type (input/output), diag‐
nostics
Names of the "PROFIBUS PA Master" interface Section "Assigning parameters
● Names of the parameter interface of the
PROFIBUS PA master
● Setting diagnostic address
● Displaying DPV0 alarms on CFU LEDs
● Comparing TAGs
● Service interface
● Manual field device integration"
Names of the status interface of the PROFIBUS
PA master
Addresses used internally (these must not be
changed)
Commissioning
8.7 Commissioning (offline)
Supplementary information
PROFINET installation > Topolo‐
gy
PROFINET functions > Topology
and STEP 7
Section "Configuring freely con‐
figurable channels (parameter
overview - DIQ) (Page 78)"
to the PA master (parameter
overview - FB M) (Page 80)"
75