Siemens Simatic CFU Commissioning Manual page 81

Objects in HW Config
Table 8-3
Tab
General
Table 8-4
Tab
General
Addresses
Parameter
Table 8-5
Tab
General
Addresses
Setting parameters
1. Open HW Config.
2. Select the CFU.
3. In the index list, double-click the object slot (e.g. parameter + diagnostics).
The dialog box opens.
4. Select the corresponding tab (e.g. "Parameter").
Note:
If PCS 7 is used, the Engineering System applies a correct parameter assignment to the
addresses. The name in the General tab can be applied unchanged.
5. Load the parameters into the CFU.
6. Make the required settings.
SIMATIC CFU
Commissioning Manual, 07/2018, A5E39252870-AC
FB M
Settings in the "PA master properties" dialog box
You can enter a name for the PA master.
Parameter + diagnostics
Settings in the "Properties..." dialog box of the PA master
● Names of the "PROFIBUS PA Master" interface
● Setting diagnostic address
● Displaying DPV0 alarms on CFU LEDs (Page 82)
● Comparing TAGs (Page 82)
● Service interface (Page 106)
● Manual field device integration (Page 83)
Status + notifications
Settings in the "Properties..." dialog box of the PA master
Name for internal addresses of the PA master
Addresses used internally (these must not be changed)
Commissioning
8.7 Commissioning (offline)
81