Siemens Simatic CFU Commissioning Manual page 69

Requirement
The CFU has been created in the automation system.
Configuring freely configurable channels
1. Open HW Config.
2. Select the CFU.
3. In the index list, double-click the "DIQ<n>" slot.
The "Properties - DIQ..." dialog box opens.
4. Enter a name for the "freely configurable channels" in the "General" tab.
5. You can modify addresses manually in the "Addresses" tab.
Note:
If PCS 7 is used, the Engineering System applies a correct parameter assignment.
Modification is not required
6. You specify the properties of the freely configurable channels in the "Parameters" tab.
You can find information on parameter assignment in section "Configuring freely
configurable channels (parameter overview - DIQ) (Page 78)".
SIMATIC CFU
Commissioning Manual, 07/2018, A5E39252870-AC
Commissioning
8.7 Commissioning (offline)
69