Mvme2100 System Installation - Motorola MVME2100 Installation And Use Manual

MVME2100 System Installation

Before installing the MVME2100 into your VME chassis, ensure that the
jumpers on J2 and J9 are configured properly. This procedure assumes that
you have already installed the PMCspan(s) if desired, and any PMCs that
you have selected.
Proceed as follows to install the MVME2100 in the VME chassis:
Dangerous voltages, capable of causing death, are present in
!
this equipment. Use extreme caution when handling, testing,
Warning
and adjusting.
Inserting or removing modules with power applied may result
in damage to module components.
Avoid touching areas of integrated circuitry; static discharge can damage
!
these circuits
Caution
1. Attach an ESD strap to your wrist. Attach the other end of the ESD
2. Perform an operating system shutdown:
3. Remove the filler panel from the card slot where you are going to
http://www.motorola.com/computer/literature
strap to the chassis as a ground. The ESD strap must be secured to
your wrist and to ground throughout the procedure.
a. Turn the AC or DC power off and remove the AC cord or DC
power lines from the system.
b. Remove chassis or system cover(s) as necessary for access to the
VMEmodules.
install the MVME2100. If you have installed one or more PMCspan
PCI expansion modules onto your MVME2100, you will need to
remove filler panels from one additional card slot for each
PMCspan, above the card slot for the MVME2100.
– If you intend to use the MVME2100 as the system controller, it
must occupy the left-most card slot (slot 1). The system
controller must be in slot 1 to correctly initiate the bus-grant
daisy-chain and to ensure proper operation of the IACK daisy-
chain driver.
Installing the MVME2100 Hardware
1
1-17