Firmware Command Buffer - Motorola MVME2100 Installation And Use Manual

Modifying the Environment

Firmware Command Buffer

5
5-16
Miscellaneous Control Register = 52060000?
The configured value is written into the MISC_CTL register of the
Universe chip.
User AM Codes = 00000000?
The configured value is written into the USER_AM register of the
Universe chip.
Firmware Command Buffer Enable = N?
Y
N
Firmware Command Buffer Delay = 5?
Defines the number of seconds to wait before firmware begins
executing the startup commands in the startup command buffer.
During this delay, you may press any key to prevent the execution of
the startup command buffer.
The default value of this parameter causes a startup delay of 5 seconds.
Firmware Command Buffer:
['NULL' terminates entry]?
The Firmware Command Buffer contents contain the BUG commands
which are executed upon firmware startup.
BUG commands you will place into the command buffer should be
typed just as you enter the commands from the command line.
The string 'NULL' on a new line terminates the command line entries.
All BUG commands except for the following may be used within the
command buffer: DU, ECHO, LO, TA, VE.
Note
Interactive editing of the startup command buffer is not
supported. If changes are needed to an existing set of startup
commands, a new set of commands with changes must be
reentered.
Enables Firmware Command Buffer execution.
Disables Firmware Command Buffer execution
(Default).
Computer Group Literature Center Web Site