Table of Contents
Advertisement
Preparation and Installation
1
Warning
Caution
1-16
Remove chassis or system cover(s) as necessary for access to the
VME module card cage.
Dangerous voltages, capable of causing death, are present in
this equipment. Use extreme caution when handling, testing,
and adjusting.
Inserting or removing modules with power applied may result
in damage to module components.
Avoid touching areas of integrated circuitry; static discharge
can damage these circuits.
3. If the Primary PMC Carrier Module/MVME2100 assembly is
already installed in the VME chassis, carefully remove the two-
board assembly from the VMEbus card slots and position it with the
P1 and P2 connectors facing you.
4. Remove the four short Phillips head screws from the standoffs in
each corner of the primary PCI expansion module, PMCspan-001.
5. Attach the four standoffs to the PMCspan-001.
6. Place the PMCspan-010 on top of the PMCspan-001. Align the
mounting holes to the standoffs in each corner, and align
PMCspan-010 connector P3 with PMCspan-001 connector J3.
7. Gently press the two PMCspan modules together, making sure that
P3 is fully seated in J3.
8. Insert the four short Phillips screws through the holes at the corners
of PMCspan-010 and into the standoffs on the primary PMCspan-
001. Tighten the screws.
Note
The screws have two different head diameters. Use the screws
with the smaller heads on the standoffs next to VMEbus
connectors P1 and P2.
Computer Group Literature Center Web Site
Hide quick links:
Advertisement
Table of Contents
