Motorola MVME2100 Installation And Use Manual page 32

Preparation and Installation
1
Caution
1-12
Inserting or removing modules with power applied may result
in damage to module components.
Avoid touching areas of integrated circuitry; static discharge
can damage these circuits.
Note
This procedure assumes that you have read the user's manual
that was furnished with the PMCspan, and that you have
installed the selected PMCs on the PMCspan according to the
instructions given in the PMCspan and PMC manuals.
1. Attach an ESD strap to your wrist. Attach the other end of the ESD
strap to the chassis as a ground. The ESD strap must be secured to
your wrist and to ground while you are performing the installation
procedure.
2. Perform an operating system shutdown. Turn the AC or DC power
off and remove the AC cord or DC power lines from the system.
Remove chassis or system cover(s) as necessary for access to the
VME module card cage.
3. If the MVME2100 has already been installed in the chassis,
carefully remove it from the VMEbus card slot and position it with
connectors P1 and P2 facing you.
Computer Group Literature Center Web Site