System Considerations; Figure 2-3 Start Up Flow Diagram - Motorola CPCI-6020 Installation And Use Manual

System Considerations

The following flowchart shows the basic initialization process that takes place during system
startup. Refer to a detailed initialization list in
Figure 2-3 Start Up Flow Diagram
Startup
System
Initialization
Console Detection
Run Self Tests
(if enabled)
Auto Boot
(if enabled)
Operating
System
2.15 System Considerations
The CPCI-6020 is designed to operate as a CompactPCI system slot board. As a system slot
board, the CPCI-6020 provides system clocks and arbitration for other peripheral slots in the
subrack. Consequently, the CPCI-6020 must be installed in a subrack system slot marked with
a triangle symbol.
The CPCI-6020 provides seven peripheral slot clock outputs (CLK0-CLK6) per CompactPCI
specification 2.0 R2.1. Arbitration for the seven peripheral slot bus masters is provided by the
CPCI-6020.
On the CPCI-6020 baseboard, the standard serial console port (COM1) serves as the PPCBug
debugger console port. The firmware console should be set up as follows:
Eight bits per character
One stop bit per character
Parity disabled (no parity)
Baud rate of 9600 baud
CPCI-6020 CompactPCI Single Board Computer Installation and Use (6806800A51C)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Hardware Preparation and Installation
Chapter 5, Firmware, on page 107.
55