YASKAWA DX200 Instructions Manual page 101

HW1481731
Alarm Alarm Name
Number
8027 ALM
FSETOOL
JOB
SIZE
(JOB size
error)
8028 ALM
FSETOOL
PALAM
(Adjustment
condition
parameter
error)
8805 ALM SEND
COMM
ALARM
8 Alarm List of FSE-Tools
Sub Meaning
Code
[0]: When the controller receives
2KBytes the JOB from PC with using
over FSE-Tool, the JOB size
[1]: exceeds the allowable size.
51 lines
over
When executing the force
control parameter adjustment
from PC with using FSE-Tool,
the adjustment condition
parameter has an error.
Communication interrupted.
Cause
Software
(Setting
error)
Software
(Setting
error)
Hardwar
e
HW1481731
8-2
Remedy
[0]:The JOB to be received
should be within 2 KBytes.
[1]:The JOB to be received
should be within 50 lines.
Then turn ON the power again.
- Connection status of the
communication cable
- Force sensor type being
connected
(2) If this alarm occurs again,
save CMOS.BIN in the
maintenance mode and tell the
situation of the alarm
occurrence (such as the
operation procedures) to your
YASKAWA representative.
Confirm Ethernet connection.
101/104