EMC VNX Series Hardware Information Manual page 9

– Two PCI Gen 2 x4 I/O module slots supporting a combination of the following
™
UltraFlex I/O modules:
a.) Two-port 10-Gb/s optical or active Twinax
10 GbE on the latch handle
b.) Two-port 10-Gb/s RJ-45 Base-T iSCSI/IP; labeled 10 GbE Base-T on the latch
handle
Note: The two-port 10-Gb/s RJ-45 Base-T/IP I/O module requires VNX OE for File
version 7.1 or later.
c.) Four-port 1-Gb/s copper iSCSI; labeled 1 GbE iSCSI/TOE on the latch handle
d.) Four-port 8-Gb/s optical Fibre Channel (running at 2, 4, or 8-Gb/s); labeled
8 GbE Fibre on the latch handle
e.) Two-port 10-Gb/s optical or active Twinax
(FCoE); labeled 10 GbE/FCoE on the latch handle
Note: The two-port 10-Gb/s optical or active Twinax FCoE I/O module requires
VNX OE for File version 7.0.35.3 or later.
– One RS-232/EIA 232 serial (up to 115 K baud) service laptop (micro DB-9) port
– One RS-232/EIA 232 serial management (micro DB-9) port
– One 10/100/1000 LAN management (RJ-45) port
– One 10/100/1000 LAN service (RJ-45) port
– One power supply (hot-swappable)
One 1U standby power supply (SPS) with a second (optional) SPS available
◆
One 2U DME with up to two Data Movers. Each Data Mover consists of:
◆
• One CPU module consisting of one Intel Xeon 4-core 2.13-GHz processor
• Six DDR3 synchronous dynamic RAM (SDRAM) slots supporting up to 6 GB per CPU
module
• One Fibre Channel (FC) I/O module with a:
– Four-port 8 Gb/s optical (running at 2, 4, or 8 Gb/s); in slot 0; labeled
8 GbE Fibre on the latch handle
• One to two of the following network I/O modules in any combination:
– Two-port 10-Gb/s optical or active Twinax
handle
– Two-port 10-Gb/s optical or Twinax
Note: Version 3 of the two-port 10-Gb/s optical or active Twinax I/O module
requires VNX OE File version 7.1 or later.
– Four-port 1-Gb/s copper; labeled 1 GbE on the latch handle
4. The two-port 10-Gb/s and FCoE I/O modules can also use active twinaxial (Twinax) cables. Twinax
is a type of cable similar to coax, but with two inner conductors instead of one. These cables will
be supplied in lieu of SFP+ transceiver modules when so ordered.
VNX5300 Block and File product description
4
(w/iSCSI protocol); labeled
3
Fibre Channel over Ethernet
4
; labeled 10 GbE v2 on the latch
4
; labeled 10 GbE v3 on the latch handle
EMC VNX5300 Hardware Information Guide 9