EMC VNX Series Hardware Information Manual page 62

I/O modules
Two-port 10-Gb/s optical I/O module
62 EMC VNX5300 Hardware Information Guide
The two-port 10-Gb/s optical or active Twinax
latch handle) comes with two optical ports, one power/fault LED, and a link and activity
LED for each port (Figure
of 10 Gb/s.
The two-port 10-Gb/s optical I/O module uses the SFP+ transceiver module (see the
section describing the SFP+
information about the SFP+ modules). The two-port 10-Gb/s optical uses the SFP+
transceiver module, hence a different part number (for part number label location, see the
VNX5300 Parts Location Guide
Note: This I/O module requires software release VNX OE for File 7.0 to function properly. It
will not function properly in software release VNX OE for File 7.1. Use the newer version
(version 3) of the two-port 10-Gb/s Ethernet optical or active Twinax I/O module as
described in the "Two-port 10-Gb/s optical I/O module"
1 2
3
4
5
CNS-001756
1 Push button latch handle
2 Power/fault LED
3 SFP+ (optical) port (two)
Figure 56 Two-port 10-Gb/s optical I/O module
9. The two-port 10-Gb/s I/O module can also use active twinaxial (Twinax) cables. Twinax is a type of
cable similar to coax, but with two inner conductors instead of one. These cables will be supplied
in lieu of the SFP+ when so ordered.
9
IP I/O module (labeled 10 GbE v2 on the
56). The optical ports on this I/O module can interface at speeds
"Four-port 8-Gb/s FC I/O module" on page 46
).
4
5
for more
section on page 64.
SFP+ link LED (right)
SFP+ NIC activity LED (left)