EMC VNX Series Hardware Information Manual page 48

I/O modules
Four-port 1-Gb/s copper iSCSI I/O module
48 EMC VNX5300 Hardware Information Guide
Four-port 8-Gb/s FC I/O module LEDs
The four-port 8-Gb/s Fibre Channel (FC) I/O module has two different types of status LEDs.
Figure 41 shows the LEDs and
Power/fault
LED
Link/Activity
LED
Link/Activity
LED
Link/Activity
LED
Link/Activity
LED
Figure 41 Four-port 8-Gb/s FC I/O module LEDs
Table 28 Four-port 8-Gb/s FC I/O module LEDs
LED Color State
Power/Fault Green On
Amber On
— Off
Link/Activity Green On
(each port
Blue On
has one
LED)
Green or Blinking
Blue
— Off
1. Refer to the VNX5300 Parts Location Guide
The four-port 1-Gb/s copper iSCSI I/O module with IPv6 (labeled 1 GbE iSCSI/TOE on the
latch handle) comes with four 1 Gb/s Ethernet Base-T copper ports, one power/fault LED,
and a link and activity LED for each copper port
interface at speeds of 1 Gb/s. The 1 Gb/s Ethernet Base-T copper ports connect to Cat 6
cabling (see Table 16, "Ethernet cabling guidelines,"
cabling guidelines," on page
TCP offload engine (or TOE).
Table 28 describes them.
CNS-001670
Description
I/O module is powered up.
I/O module has faulted.
I/O module is powered down.
2- or 4-Gb link speed (suboptimal speed)
8-Gb/s link speed (maximum speed)
Small form-factor pluggable (SFP+
faulted, unsupported, or optical cable fault.
No network connection
for the part number label location for the SFP+ part number.
(Figure
39) to an Ethernet switch. This I/O module also includes a
1
) transceiver module
42). This iSCSI I/O module can
on page 32 or Table 21, "Ethernet