EMC VNX Series Hardware Information Manual page 64

I/O modules
Two-port 10-Gb/s optical I/O module
64 EMC VNX5300 Hardware Information Guide
This new two-port 10-Gb/s Ethernet optical or active Twinax IP I/O module (labeled
10 GbE v3 on the latch handle) comes with two optical ports, one power/fault LED, and a
link and activity LED for each port
interface at speeds of 10 Gb/s.
The two-port 10-Gb/s Ethernet optical I/O module uses the SFP+ transceiver module (see
the section describing the SFP+
information about the SFP+ modules). The two-port 10-Gb/s optical uses the SFP+
transceiver module, hence a different part number (for part number label location, see the
VNX5300 Parts Location Guide
Note: This I/O module requires software release VNX OE for File 7.1 to function properly.
Consequently, you cannot mix this I/O module version (version 3) with the two-port
10-Gb/s optical or active Twinax I/O module (version 2) as described in the
10-Gb/s optical I/O module"
10-Gb/s optical or active Twinax I/O module that only functions in VNX OE for File 7.0 with
a version 3 two-port 10-Gb/s Ethernet I/O module, you must replace all of the version 2s
of the two-port 10-Gb/s Ethernet optical or active Twinax I/O modules with version 3s of
the two-port 10-Gb/s Ethernet I/O module that function in VNX OE for File 7.1. To
determine the correct version number, look at the label on the latch handle. It will say
either v2 or v3 along with the name on the label. Also, refer to the
Guide
for the location of the part number label.
1 2
3
4
5
CNS-001756
1 Push button latch handle
2 Power/fault LED
3 SFP+ (optical) port (two)
Figure 58 Two-port 10-Gb/s optical I/O module
(Figure 56). The optical ports on this I/O module can
("Four-port 8-Gb/s FC I/O module" on page
).
section on page 62. If you replace a version 2 two-port
4 SFP+ link LED (right)
5 SFP+ NIC activity LED (left)
46) for more
"Two-port
VNX5300 Parts Location