EMC VNX Series Hardware Information Manual page 58

I/O modules
Four-port 1-Gb/s copper I/O module
58 EMC VNX5300 Hardware Information Guide
Table 33 Four-port 8-Gb/s FC I/O module LEDs (continued)
LED Color State
Link/Activity Green On
(each port
Blue On
has one
LED)
Green or Blinking
Blue
— Off
VNX5300 Parts Location Guide
1. Refer to the
The four-port 1-Gb/s copper I/O module (labeled 1 GbE on the latch handle) comes with
four 10/100/1000 Base-T copper ports, one power/fault LED, and a link and activity LED
for each copper port (Figure
100 Mb/s, and 1000 Mb/s (1 Gb/s). Another way to describe this type of module is that it
runs Ethernet over twisted pair. This I/O modules uses EIA Category 6 Unshielded Twisted
Pair (UTP) cabling to an Ethernet switch (see
page 32 or Table 21, "Ethernet cabling guidelines,"
Note: The four-port 1-Gb/s copper I/O module and the two-port 1-Gb/s copper plus
two-port 1-Gb/s optical IP I/O module (see
optical IP I/O module" on page
only distinguishing difference between these I/O modules will be the SFP transceiver
modules used on ports 2 and 3.
1 2
3
4
5
CNS-001751
1 Push button latch handle
2 Power/fault LED
3 RJ-45 NIC (copper) port (four)
Figure 52 Four-port 1-Gb/s copper I/O module
Description
2- or 4-Gb link speed (suboptimal speed)
8-Gb/s link speed (maximum speed)
Small form-factor pluggable (SFP+
faulted, unsupported, or optical cable fault.
No network connection
for the correct SFP+ part number.
52). This I/O module can interface at speeds of 10 Mb/s,
Table 16, "Ethernet cabling guidelines,"
on
"Two-port 1-Gb/s copper plus two-port 1-Gb/s
60) have the same 1 GbE label on the latch handle. The
4 RJ-45 NIC link LED
5 RJ-45 NIC activity LED
1
) transceiver module
page 39).
on