EMC VNX Series Hardware Information Manual page 38

System component description
38 EMC VNX5300 Hardware Information Guide
Figure 30 shows the orientation of these components.
1
1 AC power in connector
2 PS/2 connector (mouse)—not used
3 DB-9 serial modem plug connector
4 RJ-45 Ethernet NIC port (labeled CS
5 RJ-45 Ethernet NIC port (labeled B)
6 RJ-45 Ethernet NIC port (labeled MGMT)
1. The CS port uses an IPMI (Intelligent Platform Management Interface) cable to connect to a standby Control
Station.
2. These LEDs might light during power on self test (POST); they are not important for the administration or
maintenance of the Control Station.
3. An extension cable with a label (CS 0 B) is provided with this connector (see the cable kit).
4. An extension cable with a label (CS 0 MGMT) is provided with this connector (see the cable kit).
Figure 30 VNX5300 platform Control Station (rear view)
Control Station Input/output ports and connectors
The
Block and File (Unified)
ports on the rear of the 1U Control Station:
Four Ethernet (RJ-45) NIC ports
◆
One serial modem (DB-9) plug connector
◆
One serial console (DB-9) plug connector
◆
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to
telephone-network voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports
contain TNV circuits. Some LAN and WAN ports both use RJ-45 connectors. Use caution
when connecting cables.
Control Station Ethernet (RJ-45) NIC ports
The Block and File (Unified) VNX5300 platform 1U Control Station comes with two
integrated dual-port Ethernet ports (labeled A and CS) and two Peripheral Component
Interconnect Express (PCI-E)
MGMT) in an expansion slot on the rear of the Control Station. These ports provide an
2 3
12 11
10
7
8
9
1
) 10
3
11
4
12
VNX5300 platform 1U Control Station supports the following I/O
6
low profile card dual-port Ethernet ports (labeled B and
4 5 6
CS
B MGMT
A
9 8
DB-9 serial console plug connector
Two USB 2.0 connectors—not used
RJ-45 Ethernet NIC port (labeled A)
2
POST diagnostic LEDs
DB-15 Video (VGA) socket connector—not
used
PS/2 connector (keyboard)—not used
7
CNS-001741