EMC VNX Series Hardware Information Manual page 14

System component description
3U, 25 (2.5-inch) DPE
14 EMC VNX5300 Hardware Information Guide
Table 2 VNX5300 platform 3U, 15 DPE and disk drive LEDs (continued)
LED
Disk drive on/activity
(location 5)
On the front, viewing from left to right, the Block and File (Unified) VNX5300 platform 3U,
25 (2.5-inch) disk drive DPE includes the following:
2.5-inch 6-Gb/s SAS or 6-Gb/s NL-SAS drives (hot-swappable)
◆
Status LEDs
◆
Figure 5 shows the location of these disk drives and status LEDs.
1
0
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
1 2.5-inch 6-Gb/s SAS or 6-Gb/s NL-SAS
disk drives
2 DPE fault LED (amber)
3 DPE power status LED (blue)
Figure 5 VNX5300 platform 3U, 25 DPE carrier (front view)
Color State
Green On
Blinking, mostly
on
Blinking at
constant rate
Blinking, mostly
off
— Off
2
4 Disk drive fault LED (amber)
5 Disk drive status/activity (blue)
Description
Powering and powered up
Disk drive is on with I/O activity
Disk drive is spinning up or down
normally
Disk drive is powered up but not
spinning
Note: This is a normal part of the
spin-up sequence, occurring
during the spin-up delay of a
slot.
Disk is powered down
3
5 4
24
VNX-000281