EMC VNX Series Hardware Information Manual page 66

I/O modules
Two-port 10-Gb/s RJ-45 Base-T iSCSI/IP I/O module
66 EMC VNX5300 Hardware Information Guide
The two-port 10-Gb/s RJ-45 Base-T iSCSI/IP I/O module (labeled 10 GbE Base-T on the
latch handle) comes with two 10-Gb/s Base-T copper ports, one power/fault LED, and a
link and activity LED for each port
interface at speeds of 10 Gb/s for iSCSI networks. The two-port 10-Gb/s Base-T I/O
module uses EIA Category 6 or 6a Unshielded Twisted Pair (UTP) or EIA Category 7 fully
Shielded Twisted Pair (STP) copper cabling (see
on page 32 or Table 21, "Ethernet cabling guidelines,"
1 2
3
4
5
VNXe-000751
1 Push button latch handle
2 Power/fault LED
3 RJ-45 Base-T port (2)
Figure 60 Two-port 10-Gb/s RJ-45 Base-T I/O module
(Figure 48). The Base-T ports on this I/O module can
Table 16, "Ethernet cabling guidelines,"
on page
4 Link LED (right)
5 Activity LED (left)
39).