EMC VNX Series Hardware Information Manual page 44

System component description
44 EMC VNX5300 Hardware Information Guide
Data Mover management module Ethernet (RJ-45) NIC ports
The Block and File VNX5300 platform Data Mover management module comes with three
integrated dual-port Ethernet ports (labeled 0, 1, and 2) on the rear of the Data Mover
management module. These ports support an interface for connecting to 10-Mb/s,
100-Mb/s, or 1000-Mb/s networks and provide full-duplex (FDX) capability, which
enables simultaneous transmission and reception of data.
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to
telephone-network voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports
contain TNV circuits. Some LAN and WAN ports both use RJ-45 connectors. Use caution
when connecting cables.
To access the Ethernet ports, connect a Category 3, 4, 5, 5E, or 6 unshielded twisted-pair
(UTP) cable to the RJ-45 connector on the back of the Data Mover management module, as
described in Table 16 on page
Since the Control Station and the Data Mover management module have the same type of
RJ-45 NIC ports, "Control Station Ethernet (RJ-45) NIC ports" on page 38
information about the Data Mover management module NIC ports.
Data Mover management module LEDs
Figure 38 shows the LEDs and
Power/Fault LED
Port 2 (Activity LED)
2
Port 2 (Link LED)
0
Port 0 (Link LED)
Port 0 (Activity LED)
Figure 38 Data Mover management module LEDs
32.
Table 26 describes them.
Port 1 (Activity LED)
1
Port 1 (Link LED)
Numeric display
(DME ID)
#
CNS-001671
provides detailed