EMC VNX Series Hardware Information Manual page 22

System component description
22 EMC VNX5300 Hardware Information Guide
Note: If an SPS is cabled with the SPS sense (management) cable going to the power
supply on SP A and the power-out cable going to the power supply on SP B (or the other
way around), an error condition will occur when the SPS is tested or when it is charging.
Looking from left to right,
dual 1U SPS (B and A, respectively).
1 2
SPS B (optional)
1 SPS B AC power in (recessed plug)
2 AC power out socket (not used or to DAE B) 7
3 AC power out socket to the SP B power
supply on the DPE
4 SPS A AC power in (recessed plug)
5 AC power out socket to the SP A power
supply on the DPE
Figure 11 Example of SPS B and A viewing from left to right (rear view)
SPS LEDs
Figure 12 shows the LEDs located on each SPS (A and B).
SPS power
SPS battery
SPS no battery
SPS fault
VNX-000289
Figure 12 SPS LEDs
Figure 11 on page 22 shows an example of the rear view of a
3
S/N
900-XXX-0014 0082
REV A00
SPS A
10 9
6
8
9
10
4 5 6
AC power out socket (not used or to DAE A)
Four SPS A status LEDs (green and amber)
SPS A to SP A management (RJ-12)
connector
Four SPS B status LEDs (green and amber)
SPS B to SP B management (RJ-12)
connector
S/N
900-XXX-0014 0082
REV A00
8 7
VNX-000282