EMC VNX Series Hardware Information Manual page 41

If your Block and File (Unified) VNX5300 platform includes a second optional 1U Control
Station (CS 1), another set of Ethernet cable extensions for the RJ-45 ports is provided.
These cables allow you to extend the length of the Ethernet cables from the CS 1, port B to
Data Mover Enclosure 0, management module B, port 2 and CS 1, MGMT port to the public
LAN. Each cable includes a corresponding label clip to assist you during system cabling.
Note: If you received the Block and File (Unified) VNX5300 platform already installed in a
cabinet rack with all of the Block and File (Unified) VNX5300 platform components, all the
cabling has already been installed.
Figure 33 Example of Ethernet extension (modular plug to modular jack) cable
Control Station serial console (DB-9) plug connector
The back of the Block and File (Unified) VNX5300 platform 1U Control Station includes a
standard serial console Electronics Industries Association (EIA) RS-232 interface (DB-9)
plug connector (labeled with a symbol depicting a wrench on the right). Notice the
orientation of the pins (Figure
Pin 1
5
6
9
CNS-001742
Figure 34 Control Station serial console (DB-9) plug connector
Table 24 lists the Control Station Ethernet (DB-9) pin signals used on the connector.
Table 24 Control Station (DB-9) plug connector pinout
DB-9 Pin Signal
1 CD
2 RXD
3 TXD
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9 RI
34).
Description
Carrier detect
Received data
Transmitted data
Data terminal ready
Ground
Data set ready
Request to send
Clear to send
Ring indicator (not used)
EMC VNX5300 Hardware Information Guide
System component description
VNX-000564
41