EMC VNX Series Hardware Information Manual page 10

VNX5300 Block and File product description
10 EMC VNX5300 Hardware Information Guide
– Two-port 1-Gb/s copper plus two-port 1-Gb/s optical; labeled 1 GbE on the
latch handle
– Two-port 10-Gb/s RJ45 Base-T iSCSI/IP; labeled 10 GbE Base-T on the latch
handle
Note: The two-port 10-Gb/s RJ-45 Base-T/IP I/O module requires VNX OE for File
version 7.1 or later.
• Two management modules per DME (or, one per Data Mover)
• Two power supply/cooling (fan) modules per CPU module
One or two Control Stations. Each Control Station consists of the following features:
◆
• Intel 2.0 GHz single core Celeron processor with 800-MHz front side bus (FSB) and
512 KB cache
• 2 GB of RAM
• One 250-GB SATA hard drive
• Two rear-mounted USB ports and one front-mounted USB port
• Four 10BASE-T/100BASE-TX/1000BASE-T network interface (RJ-45) connectors
(located on the rear panel)
• Two integrated serial ports, one for laptop/console redirection and one for the
CallHome modem
• One DVD-ROM drive
Expansion of up to seven 3U, 15 (3.5-inch) DAEs (a maximum of 120 drives) or up to
◆
four 2U, 25 (2.5-inch) DAEs (a maximum of 125 drives)
IMPORTANT
When calculating the number of drives for your Block and File (Unified) VNX5300 platform,
the 3U DPE is included in the total drive slot quantity of 120 to 125 drives. If the total drive
slot quantity exceeds 120 or 125, you will not be able to add another DAE. Refer to
"Disk-array enclosure" on page 68
DAEs for the Block and File (Unified) VNX5300 platform.
Any required cables including LAN cables, modem cables, and serial DB-9 cable.
◆
Mounting rails with hardware
◆
Front bezel with VNX5300 badge
◆
for more information about the available expansion