EMC VNX Series Hardware Information Manual page 56

I/O modules
Data Mover I/O module types
Four-port 8-Gb/s FC I/O module
56 EMC VNX5300 Hardware Information Guide
The following I/O module types are supported by the Block and File (Unified) VNX5300
platform Data Mover:
"Four-port 8-Gb/s FC I/O module"
◆
"Four-port 1-Gb/s copper I/O module" on page 58
◆
"Two-port 1-Gb/s copper plus two-port 1-Gb/s optical IP I/O module" on page 60
◆
"Two-port 10-Gb/s optical I/O module" on page 62
◆
"Two-port 10-Gb/s optical I/O module" on page 64
◆
"Two-port 10-Gb/s RJ-45 Base-T iSCSI/IP I/O module" on page 66
◆
Note: For SP module types, go to
The four-port 8-Gb/s FC I/O module (labeled 8 GbE Fibre on the latch handle) comes with
four optical (fibre) ports, one power/fault LED, and a link/activity LED for each optical port
(Figure 50). This I/O module can interface at speeds of 2, 4, and 8 Gb/s. Besides optical
SFP or SFP+, it uses OM2/OM3 multimode optical fiber type cabling to connect directly to
a host HBA or FC switch. OM2 cabling can usually be distinguished by the orange color of
the cable. While, OM3 cabling can be dis tin gui sed by the aqua color of the cable.
1 2
3
4
CNS-001752
1 Push button latch handle
2 Power/fault LED
Figure 50 Four-port 8-Gb/s FC I/O module
on this page
"SP I/O module types" on page
3 SFP+ (optical) port (four)
4 SFP+ link/activity LED
46.