Installation - Eicon Networks Diva Server Series Installation Manual

Installation

This chapter will assist you in installing your Diva Server adapter and connecting it
to your ISDN BRI, ISDN PRI, E1, T1, or analog line.
You need to complete the following three procedures to use your Diva Server
adapter properly:
• (A) Insert your Diva Server adapter into your computer as described below.
• (B) Connect your Diva Server adapter as described on page 24.
• (C) Install your Diva Server adapter software as described on page 35.
Note: You may need your computer's manual during the installation of your
adapter.
(A) Insert your Diva Server adapter into your computer
For your safety, disconnect all technical and peripheral devices and all energy
1.
sources from the computer,
Drain static electricity from your body by touching the metal chassis (the
2.
unpainted metal at the back of your computer).
Remove the ISDN cable, if present, and the power cord from your computer.
3.
Remove the cover of the computer as described in your computer's manual.
4.
Locate a PCI or PCIe slot in your computer.
5.
If there is a metal plate at the end of the slot, remove the screw or loosen the
6.
clip and remove the metal plate. Keep the screw for fastening your adapter.
If your adapter comes with a retainer, and space does not permit the use of the
7.
retainer, simply remove it before you insert the adapter. The retainer is only an
installation aid and does not add functionality to the adapter.
22
VoIPon www.voipon.co.uk
Installation
sales@voipon.co.uk
retainer
Tel: +44 (0)1245 808195 Fax: +44 (0)1245 600030