DURKOPP ADLER 906 Operating Instructions Manual page 79

Programming
Operating Instructions 906 - 02.0 - 11/2016
MP4 - Thread cutting
Symbol Meaning
Cutting speed
(min. = 70 .. max. = 500; Def. =180 rpm)
Speed of the cutting stitch.
Cutting position on
(min. = 0 .. max. = 359; Def. = 180 °)
Angular position of the needle at which the thread cutting knife is switched
on.
Cutting position off
(min. = 0 .. max. = 359; Def. = 359 °)
Angular position of the needle at which the thread cutting knife is switched
off.
Thread tension during thread cutting
(min. = 0 .. max. = 100; Def. = 10 %)
Thread tension of the cutting stitch.
Position for thread tension during thread cutting
(min. = 0 .. max. = 400; Def. = 370 °)
Starting angle for the thread tension during the cutting stitch.
(At an angle greater than 359 ° the thread tension is activated in the next
stitch.)
MP5 - Clamping thread
Symbol Meaning
Close thread clamp at 1st stitch
(min. = 0 .. max. = 250; Def. = 180 °)
Start angle for closing the thread clamp during the first stitch.
Open thread clamp at 1st stitch
(min. = 0 .. max. = 359; Def. = 340 °)
Starting angle for opening the thread clamp during the first stitch.
If the closing and opening angles are the same then the thread clamp is not
activated.
77