DURKOPP ADLER 906 Operating Instructions Manual page 59

Programming
Seam parameters for teach-in
Drawing a path
7. Use the arrow buttons to move the cursor to the end point of the desired
Information
Alternatively, you can tap an arrow button once in order to define the
direction and then continue moving in this direction by pressing the pedal.
Important
Take care to ensure that the contour remains within the permissible
sewing field of your particular machine. Especially with curved paths, you
should remember that the start and end points are not directly connected
and that a curve is generated between these two points.
8. Confirm with OK.
 The seam path is adopted with the specified parameters.
Adding further seam paths
Further seam paths are defined using the same procedure.
9. Add each new seam path by starting at step 4 ( p. 56).
Operating Instructions 906 - 02.0 - 11/2016
Button Meaning
Speed
Stitch length
Thread tension
Stroke height
Thread cutting
path.
57