DURKOPP ADLER 906 Operating Instructions Manual page 32

Abb. 18: Changing the bobbin (2)
(3) - Bobbin
(4) - Bobbin case retainer
(5) - Guide
2. Swivel up the bobbin case retainer (4).
3. Remove the empty bobbin.
4. Insert a full bobbin (3).
Important
Insert the bobbin (3) so that it moves in the opposite direction of the hook
when the thread is pulled out.
5. Feed the hook thread through the slot (7) in the bobbin case retainer.
6. Pull the hook thread under the tension spring (6).
7. Feed the hook thread through the guide (5) and pull it approx. 3 cm
8. Close the bobbin case retainer (4).
9. Release the threading mode (1) push button.
 The cover plate (2) swivels back to the original position.
10. If the bobbin has been changed by the program without being requested
Information
If the bobbin has been changed because it was empty, the thread
consumption will be counted from full bobbin capacity after a bobbin
change.
30
③
④
⑤
⑥
⑦
further.
to do so (e.g. in the event of a color change), tap the
change button on the main screen.
This confirms that a new bobbin has been inserted and that the thread
consumption must resume counting from the value corresponding to
the full bobbin capacity.
(6) - Tension spring
(7) - Slot
Operating Instructions 906 - 02.0 - 11/2016
Operation
Bobbin