DURKOPP ADLER 906 Operating Instructions Manual page 28

Important
The thread guide must be parallel to the thread stand.
3. Use a compressed air gun to blow the thread through the hose guide.
Information
To blow the thread through the hose guide, position the compressed air
gun together with the end of the thread at the upper end of the hose guide.
Briefly squeeze the trigger once.
4. Insert the thread through the guide (11): From the rear to the front
5. Feed the thread counterclockwise around the tensioner (10).
6. Feed the thread clockwise around the tensioner (9).
7. Insert the thread through the guides (8) and (7).
8. Feed the thread clockwise around the diverter (6).
9. Feed the thread under the thread tensioning spring (5), through the
10. Feed the thread through the thread lever (1) and thread guide (4).
Abb. 14: Threading the needle thread (2)
(12) - Needle thread monitor
(13) - Thread clamp
11. Insert the thread through the needle thread monitor(12) and the thread
12. Insert the thread through the guides (14) and (15).
13. Insert the thread through the needle eye in such a way that the loose
26
through the uppermost hole, from the front to the rear through one of
the middle holes, from the rear to the front through one of the lower
holes.
guide(3) and through the thread regulator (2) to the thread lever (1).
clamp (13).
thread end faces the hook.
⑫
⑬
⑭
⑮
(14) - Guide
(15) - Guide
Operating Instructions 906 - 02.0 - 11/2016
Operation