Configure D60X Using Rdm - ETC Desire Series User Manual

Configure D60X using RDM

Up to 32 D60X fixtures can be daisy-chained on a DMX/RDM network. Each fixture can have an unique
DMX address, and each address can be configured separately. Also, more than one fixture can have
the same address, allowing you to configure fixtures identically.
You can use an RDM configuration tool or an RDM lighting control device to configure the fixtures. An
RDM configuration tool is installed on a PC, which is connected to the DMX/RDM network via
Gadget II or a DMX/RDM gateway. After the fixtures are configured, Gadget II or the gateway can be
disconnected and a DMX or RDM control device can be connected to the network for continued
operation.
Connect using Gadget II
See
Gadget II
Figure-4.47 Architecture of a Desire series fixture network
Operation
page 78 Connect using a DMX/RDM Gateway
on or
Computer with Net3 Concert
or UpdaterAtor
Or
Junction
box
Junction
box
Junction
box
Up to 32 fixtures
on
DMX/RDM
gateway
Console
Desire fixture
Desire fixture
Desire fixture
page 79
.
77