ETC Desire Series User Manual page 75

I n d i v i d u a l C o n t r o l ( I n d C n t l )
Use Individual Control to select each LED series and then adjust its intensity.
1: On the Test screen, scroll to Action.
2: Press [
3: Press [
Action:
Chase:
G O
56 00
Figure-4.36 Test Screen in Individual Control Mode
4: Press [
5: Press [
The value you entered for the first series is applied to the next series.
6: Press [
7: Press [
Recalibrate Fixture
Service technicians may use this option to calibrate the constant current driver electronics for the LEDs.
The calibration process goes through each series of LEDs, starting at 0 intensity and stepping up to
100%. The calibration is automatic and takes less than a minute. During this time, do not exit the
screen until it is complete.
CAUTION:
1: On the Diagnostics screen, scroll to Recalibrate Fixture.
2: Press [
3: When asked if you are sure, select Yes and press [
A new screen shows that the calibration is in progress and whether the LEDs pass the calibration.
Figure-4.37 LED Calibration Screen with Calibration in Process
4: Press [
Operation
] until the Ind Cntr option displays. One of the LED series will illuminate.
] to select the series.
Diagnostics
Test
Ind Cntr
15 steps/sec
Individual Control
R A O R
00 00 00 00
] or [ ] to set the intensity of the series.
] to move to the next series.
] or [ ] to change the intensity of the series.
] to return to Action.
This calibration process does not measure or recalibrate the light output of
the LEDs.
Under normal use, it is not necessary to recalibrate the fixture, and doing so
will likely have no beneficial effect on fixture performance. It is therefore
NOT recommended to recalibrate the fixture without express instruction
from an authorized technician.
].
Diagnostics
Recalibrate Fixture
This Will Calibrate
LED Array
Are You Sure?
Yes
No
] or [ ] to return to the Diagnostics screen.
I
00
].
LED Calibration
LED 1 .......Pass
LED 2 .......Pass
LED 3 .......Pass
LED 4 .......Working
LED 5 .......Working
LED 6 .......Working
LED 7 .......Working
69