ETC Desire Series User Manual page 44

DMX
Profile Channels
7
Plus
additional
Seven
channels
1
Strobe additional
channel
D40XT, D40, D60 and D60X (Studio Tungsten and Studio Daylight) and
D22 (Studio Tungsten and Studio Daylight)
DMX
Profile Channels
Studio 3
Direct 3
38
Channel Assignments
DMX
Vivid, Lustr+
1 - Hue (coarse)
2 - Hue (fine)
3 - Saturation
4 - Intensity
5 - Strobe
6 - n/a
7 - Plus Seven Control on/off
8 - Red
9 - Orange (white if Lustr+)
10 - Amber
11 - Green
12 - Cyan
13 - Blue
14 - Indigo
DMX
Channel Assignments
1 - Intensity
2 - Strobe
3 - Fan Control
(D60 only)
1 - Intensity
2 - Strobe
3 - Fan Control
(D60 and D60X)
Studio HD
Adds seven additional color control
channels to RGB, HSI, HSIC, and
Studio input profile settings. For
example, HSI with 'Plus Seven'
enabled becomes a 15-channel
profile.
The desired color and intensity are
achieved by using the HSI or RGB
channels.
Placing channel seven at a value over
51% gives the fixture a 14-channel
profile.
Channels 8–14 represent the native
colors of the fixture and allow the
operator to adjust individual color
channels to fine-tune the color
output.
Variable strobe control: 0% is no
strobe. The fixture output will strobe
more rapidly as the strobe-channel
value approaches 100%.
Direct control of each individual color
with a separate master intensity
channel. Color calibration of LEDs is
not active in this mode. The ten-
channel profile will produce the
highest quality color crossfades.
Notes
Notes
Desire Series v1.8.0 User Manual