ETC Desire Series User Manual page 66

E d i t ( S t u d i o D a y l i g h t a n d S t u d i o T u n g s t e n )
Use Edit to change the brightness and strobe settings of the LED array.
To keep your changes, be sure to select Save Changes and then press
[ ] at any time.
If the Preset is currently active, the changes made on the Preset Edit screen update to the fixture output
immediately.
1: On the Presets menu, scroll to Edit and press [
Preset:
Int:
Strobe:
Save Changes
Figure-4.20 Edit Preset Screen (Studio Daylight and Studio Tungsten)
2: Scroll to any of the parameters on the screen and press [
3: Press [
4: Press [
5: Do one of the following:
• Scroll to Save Changes and press [
• Press [
Note:
C o p y t o O t h e r F i x t u re s
If other fixtures are connected to the same data chain, you can copy the Preset values to the other
fixtures. The fixture automatically becomes the Master and controls all the other fixtures (Slaves) in the
chain until another fixture has its Preset or Sequence settings selected or activated. For more
information, see
1: On the Presets screen, scroll to Copy to Other Fixtures.
Preset:
Status:
Fade Time:
Delay Time:
Edit Color
Copy to Other Fixture
Save DMX as Preset
Figure-4.21 Copy the Preset to Other Fixtures
2: Press [
3: When asked if you are sure, select Yes and press [
60
Preset 23 Edit
] or [ ] to change the values.
].
] to exit the screen without saving the changes.
If a Preset is edited, it must be copied to other fixtures in the data chain and
reactivated before the changes will take effect. If the Preset is not copied, the
changes will not carry over to other fixtures and the same Preset number will produce
different looks across fixtures in the chain.
Master/Slave Operation
Presets
Active
00:02
00:00
].
].
23
100%
0
].
page 66
on .
* 23
].
[ ].
To discard changes press
].
Desire Series v1.8.0 User Manual