Rdm Parameters - ETC F-Drive R12 Series Installation Manual

RDM Parameters

Note:
RGBW luminaires are not set to unique channels using the channel rotary switch on the
side of the Navis RGBW luminaire. See the ArcSystem Navis 100 Installation Guide for
details on Navis RGBW luminaire installation.
Parameter
Status Messages
Device Info
Device Model Description
Manufacturer Label
Device Label
36
F-Drive Chroma Card RDM communication may not function properly if Navis
RDM PID Value
0x0030 See RDM E1.20-2006
0x0060 See RDM E1.20-2006
0x0080 ASCII string for model description
0x0081 ASCII string for manufacturer label Get returns "ETC"from the root (control card) only.
0x0082 ASCII string for device label
Notes
Errors will be in the format: "Error type: [data value
1][data value 2]
Control Card:
Board overtemp E120_STS_OVERTEMP[0000]
•
[Temp degrees C]
Fan 1/2 Error E120_STS_FEEDBACK_ERROR[fan
•
number][not used]
Emergency Error E120_STS_DIM_PANIC[0000]
•
[0000]
Chroma Card:
Board overtemp E120_STS_OVERTEMP[Sensor
•
Number][Temp degrees C]
Fixture overtemp E120_STS_OVERTEMP[Sensor
•
Number][Temp degrees C]
Fixture calibration error E120_STS_CAL_FAIL
•
[E120_SD_UNDEFINED][not used]
Fixture no serial number E120_STS_NOT_READY
•
[E120_SD_UNDEFINED][not used]
Fixture overcurrent/short circuit E120_STS_
•
OVERCURRENT[0][0]
Other Output Cards:
Board overtemp E120_STS_OVERTEMP[Sensor
•
Number][Temp degrees C]
Board overcurrent/short circuit E120_STS_
•
OVERCURRENT[0][0]
Root (control card): reports a footprint of 0 and a
•
start address of 0xFFFF.
Subdevices (output card channels): in patched or
•
straight mode, all output card channels report
their current addresses and a footprint of 1. There
are 48 output card channels.
Chroma Card will report a footprint of 4 in
•
IRGB mode or 5 in Direct mode. See
DMX Personality on the facing page
Root Device: "F-Drive R12"
•
Subdevices (output card channels): the installed
•
card type that contains the channel.
Chroma Card: "Chroma"
-
FTW-150 Card: "FTW-150"
-
CV-150 Card: "CV-150
-
ArcLamp 150 Card: "ArcLamp-150"
-
CC-150 Card: "CC-150"
-
Get or Set
root device (control card): "F-Drive R12"
•
subdevices (output cards) : "[channel] %d" where
•
%d is the channel number 1–48.
.
R12 Installation Manual