D40, D60 Connections; D40Xt, D60X Connections; D22 Portable Dmx/Rdm Connections - ETC Desire Series User Manual

D40, D60 Connections

• Connect the AC cable: Align and insert the power connector. Twist the connector clockwise until
it locks into place.
• Disconnect the AC cable: Slide back the locking tab to unlock, twist the connector
counterclockwise, and then pull and disconnect the power connector.
• Connect the DMX cable: Align and insert the DMX connector.
• Disconnect the DMX cable: Press the release button on the connector or on the fixture and pull
the connector out.

D40XT, D60X Connections

• Connect the AC cable: Align and insert the connector on the fixture's power cord to the mating
connector on the extension cord or adjacent fixture. Twist the enclosure rings together to form
a tight seal.
• Disconnect the AC cable: Loosen the enclosure rings around the connectors until fully separated,
and then pull apart the two connectors.
• Connect the DMX cable: Align and connect the DMX connectors, pushing firmly until the locking
tabs are fully activated.
• Disconnect the DMX cable: Press the release button on the connectors and pull the connectors
apart.

D22 Portable DMX/RDM Connections

• Connect the DMX cable: Align and connect the DMX connectors, pushing firmly until the locking
tabs are fully activated.
• Disconnect the DMX cable: Press the release button on the connectors and pull the connectors
apart.
Installation and User Interface 25